Autocad14 Conversions

[PJaffee]

I used to be able to scan a file in Paperport (don't know which version), save it to Corel Draw r.7 and then save it in DXF format and import it to Autocad r.14. I think I had to make sure that I imported it to AutoCad as an "older" version because the Corel save was not compatible with the, at that time, newer version of AutoCAd. Anyway, I've upgraded to Corel r.11 and can't seem to get the DXF file into Autocad. Any suggestions? Thanks

[Guest]

Originally posted by PJaffee@May 9 2004, 10:57 AM
I used to be able to scan a file in Paperport (don't know which version), save it to Corel Draw r.7 and then save it in DXF format and import it to Autocad r.14. I think I had to make sure that I imported it to AutoCad as an "older" version because the Corel save was not compatible with the, at that time, newer version of AutoCAd. Anyway, I've upgraded to Corel r.11 and can't seem to get the DXF file into Autocad. Any suggestions? Thanks
wrong section for this garble, this is requests duck , i reckon ya should of been in the general section,